Sort by:
Discussions | Replies | Latest Activity |
---|---|---|
![]() Error for LEED calculation - Input past end of lineHi I have a model where I am trying to run the LEED sDA and ASE analysis. It is a large building, with some complex geometry and not so cl… Started by Sarah Leenknegt |
0 | Jan 29 |
![]() Failed to recognize student licenseI received the *.lic file, renamed and saved per instructions. However, I'm still getting the same software expiration message. Suggestio… Started by Justin Brechtel |
8 |
Jan 25 Reply by Daniela Carter |
![]() Dynamic shadingWith the dynamic shading could I get the angle of shading as output from Diva?I have a simple model just a room with single window, I wante… Started by Ahmed |
0 | Jan 15 |
![]() LEED v4 Daylight sDA - virtual shadesHi We have done several daylight project with DIVA and are familiar with the grid-based climate-based simulations as well as with the deta… Started by Sarah Leenknegt |
1 |
Jan 15 Reply by Sarah Leenknegt |
![]() Exterior Illuminance Overcast Sky Daylight FactorDear all, Currently I am trying to calculate the Average Daylight Factor with DIVA 3.0 in grasshopper. By running two simulations and onl… Started by Cindy Lei |
0 | Aug 15, 2018 |
![]() mechanical ventilation in thermal simulationHi everyone, I am simulating the cooling load of a shoebox room (6m*8m) with windows on three walls in DIVA-for-Rhino. The actual mechanic… Started by Michelle |
0 | Jul 20, 2018 |
![]() turncated octree fatal error and raypathHi, I am trying to run this daylighting analysis UDI, and my model is exported from revit. I keep getting this error and my simulation fai… Started by Zahra Mirian |
0 | Jul 17, 2018 |
![]() Units in Thermal AnalysisHello everyone It is the first time I do thermal single-zone analysis and I have a question regarding the units of the obtained results.The… Started by kullboys |
0 | Jul 12, 2018 |
![]() microsoft VBScript runtime errorGetting the following error and cannot run results of calcs for Spatial Daylight Analysis. Microsoft VBScript runtime error Overflor: 'CIn… Started by Leela Shanker |
2 |
Jun 7, 2018 Reply by saram |
![]() sDA100/50%Hello again, Is there any way to run the LEED V4/IES LM-83 sDA simulation using sDA 100/50%. ie (100 lux instead of 300) I do not requi… Started by ErenW |
0 | May 25, 2018 |
Getting Started
Advanced DIVA for Rhino Concepts
Simulation Types
Tips & Tricks
© 2019 Created by jeff niemasz.
Powered by