DIVA Grasshopper Community -

I'm having a problem trying to simulation manual blind control in the DIVA grasshopper environment.  When I try to run the simulation, the command prompt never pops up and the file is frozen.  This has happened to me on two different models on two different computers in the office --- so I though it was time to post to the forums. 

Attached is the grasshopper definition with internalized geometry data in the BREPs.  I've added the following hidden inputs to the DIVA window component:

  • set 'RollerShade_AutoGenerate' for shading geometry input
  • set 'manual' for the shading control input
  • set the spacing of the control points to 5'
  • set 1' for the minimum area input. 

Any insight would be appreciated!  Thanks y'all!

Cheers,

-Jacob Dunn

Tags: DIVA, blind, control, dynamic, grasshopper, manual, shading

Views: 45

Attachments:

Reply to This

Replies to This Discussion

Hi Jacob,

Your definition runs fine on my end.  I'm using v4.0.2.54.  (You can right click on the black bar in the center of the components to check your version #.)  Do other Annual Daylight definitions work for you?  e.g. the example files in C:\DIVA\ExampleFiles\Grasshopper\Daylight?

Jon

Reply to Discussion

RSS

© 2017   Created by jeff niemasz.   Powered by

Badges  |  Report an Issue  |  Terms of Service