I am working on CHPS certification and need hourly illuminance data for the following dates and times:
Winter Solstice 9:00am, 12:00pm, 3:00pm
Summer Solstice 9:00am, 12:00pm, 3:00pm  
Equinox 9:00am, 12:00pm, 3:00pm 
I've set up the hourly illuminance definition in grasshopper and it works well. I simply need a way to export the data for the above times only, as we need to calculate the max illuminance to average illuminace for CHPS.
When I run the simulation in Rhino (not using grasshopper) I receive output data (attached) which is really helpful within Rhino.
I'm sure this can be done but I'm not sure how. Any advice on how to bake out this specific information?
Thanks!

Tags: data, diva, grasshopper, illuminance, rhino

Views: 149

Attachments:

Reply to This

Replies to This Discussion

Hi Francis, 

I would recommend using DIVA for Grasshopper's "Illuminance" component and setting the specific date and time in the "Sky" component. This will allow you to run the analysis just for a given hour. Since you only have 9 hours to simulate, this should be relatively quick. If you need to simulate the sky based off of the climate file, you can select that option in the "Type" pull down. However, for CHPS compliance, I would suspect that they may set a certain sky condition under which to model? If its a clear sky, then that option is also available and the "Illuminance" workflow and the proposed workflow is preferred instead of using"Annual Daylight" since "Annual Daylight" will use the climate file, which will have inconsistent sky conditions across your critical dates and hours. 

Reply to Discussion

RSS

© 2019   Created by jeff niemasz.   Powered by

Badges  |  Report an Issue  |  Terms of Service