I am running a point in time illuminance for a LEED v3 analysis. The default thresholds for illuminance are the LEED bounds 108-5400 lux, but there is no distinction for the sensors falling outside of this range.

Is there any way to input a custom gradient for the component so I could highlight the area outside of the bounds or just change the colors if desired? I could recolor the mesh faces based on the data output but I am a fan of the blended look.

Views: 160

Reply to This

Replies to This Discussion

Hi Elliot,

Afraid not.  Perhaps we can add this at some point (similar to the Data Viewer), but for now you'll have to go rogue with the discrete faces.  If you have a discontinuous color scale, discrete display is probably better anyway. :)


Reply to Discussion


© 2019   Created by jeff niemasz.   Powered by

Badges  |  Report an Issue  |  Terms of Service