I am just wondering if one can change the result in Rhino/ Diva the results into Isolines...and if there a possibility to specifiy the steps in Legend? ( for instance if i need 1%, 1,5%, 2%, 2,5%....etc in Daylight factor's Legend)

Thanks for your reply,


Tags: Isolines, Legend, Skala, and, in

Views: 191


Reply to This

Replies to This Discussion

Hi Joseph,

This is not possible directly in DIVA. You could make a custom display in Grasshopper by mapping the height of a parametrically controlled surface to the results and cutting the surface at defined vertical intervals, but this relies upon doing a lot yourself.



Reply to Discussion


© 2020   Created by jeff niemasz.   Powered by

Badges  |  Report an Issue  |  Terms of Service