Hello everyone,

I just started using DIVA and Rhino yesterday, and was doing a test run on daylight autonomy calculations for a southeast facing room.When I got the results, I noticed the node numbers are backwards (see picture above). Does that mean that the grid/meter direction for these nodes was set backwards? If so, how do you go about fixing this?

Thank you in advance!

Luis

Views: 66

Reply to This

Replies to This Discussion

I would try using the surface direction command. Type "DIR" select your surface used to generate your grid and try swapping the UV. Then reapply the grid and rerun your analysis that should fix it

Hello Fabian,

Thank you for responding to my question. I tried that after going through some of the other discussion forums, and while the results make sense, the text still shows up backwards. I'll try it once again, though.

Luis

Reply to Discussion

RSS

© 2018   Created by jeff niemasz.   Powered by

Badges  |  Report an Issue  |  Terms of Service