Hi there,

Sometimes when I generate grids, the mesh faces are jagged. I attach a screenshot. Even at the same model some of the grids are fine but some are not. Any ideas why this might happen or anyone else has this problem? Thanks.

grid.JPG

//Nala

Views: 42

Reply to This

Replies to This Discussion

Yeah, the grid trimming can fail from time to time.  Are these grids very small?  My only idea would be to play with the file units...

Jon

Hi Jon,

Thank you for the reply. It has happened to big grids as well.

I didn't really understand though. What do you mean by file units?

//Nala

Units of the Rhino file (meters, millimeters, etc.).  Sometimes these (in combination with the document tolerance) can affect the trim.

Okay! Thank you Jon!

See part (4) of my response to this discussion:

http://diva4rhino.com/forum/topics/diva-grasshopper-radiation-map-i...

I'll bet tightening the document tolerance a bit (and refreshing the component) would eliminate your hanging chads.

Jon

Reply to Discussion

RSS

© 2017   Created by jeff niemasz.   Powered by

Badges  |  Report an Issue  |  Terms of Service