Hi everyone, 

I am computing the cooling load of a shoebox room with window.

By default, in the C:\DIVA\Thermal\Rhino\05_gains_conditioning.idf file, the cooling limit is UnLimited as defined below:

NoLimit, !- Cooling Limit
, !- Maximum Cooling Air Flow Rate {m3/s}
, !- Maximum Total Cooling Capacity {W}

I set air flow rate 0.05m3/s and cooling capacity 500kW, by making the following changes:

, !- Cooling Limit
0.05, !- Maximum Cooling Air Flow Rate {m3/s}
500000, !- Maximum Total Cooling Capacity {W}

After I run thermal analysis, these changes are reflected in the auto-generated .idf file in ProjectName-DIVA/thermal folder. However, it seems that the changes are not used in the simulation as the simulation results remain unchanged. 

Any advice how should I define the cooling limit? Thanks!

Tags: analysis, cooling, limit, thermal

Views: 47

Reply to This

© 2019   Created by jeff niemasz.   Powered by

Badges  |  Report an Issue  |  Terms of Service