I'm trying to return a default low res visualization of my complex model but I keep running into the same error. I'm unsure what is causing the error but I've uploaded the two alerts. I'm hoping you see a glaring mistake that I've been overlooking.
The error ("set overflow in addobject") usually occurs when you have polygons of extraordinarily small area with long edges and/or a lot of overlapping geometry. If it is possible to clean up the meshing of your model, it might solve the problem.
thanks Alstan! Is there a "maximum" number of mesh faces I should be looking to reduce my model to?
Its hard to say. The absolute amount isn't usually a problem (I've had models as large as 16M triangles), but the proportions of the edge length to surface area of each triangle can often be a problem in building a rational octree for simulation. If you can share your model, I can probably offer better advice.
Thanks again for your help. I reduced the polygon count and cleaned up some meshes and was able to run the metrics without error. Thank you.