ErenW
  • Canada
Share

ErenW's Friends

  • Sandy Houck

ErenW's Discussions

sDA100/50%

Started May 25 0 Replies

Hello again,Is there any way to run the LEED V4/IES LM-83 sDA simulation using sDA 100/50%.  ie (100 lux instead of 300) I do not require the ASE component of the LEEDv4//IES LM-83 if that…Continue

 

ErenW's Page

Comment Wall (1 comment)

At 4:30pm on September 24, 2015, Sandy Houck said…

Hi Eren,

Sorry for delayed response.  I have not looked into this much further.  To be honest the process seemed more complicated & time-consuming than I had time for during that project so I think I maybe used the 20% material definition that was in the basic material.rad file.  Alstan had sent me the attached document that explains the process. 

Good luck & I'd love to hear if you do figure out how to do it!

SandyDevelopment%20and%20validation%20of%20a%20Radiance%20model.pdf

You need to be a member of DIVA for Rhino to add comments!

Join DIVA for Rhino

 
 
 

© 2018   Created by jeff niemasz.   Powered by

Badges  |  Report an Issue  |  Terms of Service